Trombetta S500-A50 Electronic Control Module 12/24 Volt

Trombetta S500-A50 Electronic Control Module 12/24 Volt
Article number:
S500-A50, S500A50
Applications:
Trombetta's S500-A50 electronic control is a special module designed to improve solenoid performance by increasing power capacity and reducing operating temperature. Some applications require high power capacity in a relatively small package. To achieve this solution, solenoids have typically been designed with a two-section coil: a "high current pull-in coil" and a "low current hold coil, continuous operation". This solution required the "high current pull-in coil" to be electrically disconnected once the solenoid had pulled in, leaving only the "low current hold coil" energized. With the S500-A50 module, it is not necessary to disconnect the "high current pull-in coil" after the solenoid has pulled in. The module has been designed to operate properly with either a two-section coil or a single-section coil, as follows: When power is applied to the module, it supplies full voltage to the solenoid coil(s). After the activation time, the module reduces the output voltage to the solenoid to 13% - 16% of the input voltage for continuous operation. This reduced voltage level is applied to the coil(s) until power is removed. The flexibility to operate with either two-section or one-section coils allows the module to be used as a replacement for older relay style modules. The module does not require an additional contactor for 24V applications. MurCal is an authorized distributor of Trombetta products. As an approved and authorized distributor, MurCal stocks and ships every product order from our warehouse in Palmdale, California. MurCal provides application and product support, pre- and post-sales. Our in-house technical sales staff has been trained by Trombetta and has the knowledge necessary to answer your questions. When making an important purchasing decision, be sure to consider the company that provides Trombetta’s factory authorized sales and service.
Specification:
S500-A50 electronic control module, 12/24 Volt
Electronic solenoid controls regulate the amount of electrical drive applied to the coil during the solenoid retracting and/or holding operation to optimize solenoid performance.
The S500-A50 module allows you to include single or double coil solenoids in your applications. The module accepts your 2-wire or 3-wire switched input (12V or 24V), and applies this input to the solenoid